Zebra (ZPL) Printers

These options apply only to ZPL output. For printer DPI settings, see Output Resolution.

`header`

Commands sent to printer at job beginning (Sample: header="^XA^MMC^XZ" to set print mode to cutter).

Commands sent to printer at job ending.

none, rle, png or zip specifies the image compression for graphics embedded in ZPL.

Specifies the metric value for the ZPL LT (label top) command (zpl-lt='3.2mm', zpl-lt='-4').

Default unit is mm. If required you can specify other units like in, cm, m, mil, etc.

If empty (zpl-lt=''), the LT command will not be included in the generated ZPL output.

Specifies the metric value for the ZPL LS command (label shift) (zpl-ls='3.2mm').

Default unit is mm. If required you can specify other units like in, cm, m, mil, etc.

If empty (zpl-ls=''), the LS command will not be included in the generated ZPL output.

Specifies if zpl comments (including document name, resolution etc.) should be added to the generated zpl data.

Default is no.

Specifies if the generated image that is embedded in the zpl data should be cropped or not (default is on).